EXI-450 Helicopter — Build Day 1

I’m excited to be building this bird. I will say though, it’s a fair bit of work! Might be little much for a beginner getting into a hobby. I’ve been building models so long, I can’t exactly recall when I started! 4 decades of building is coming in handy here!

Perhaps it’s bad form, bad marketing, bad writing. Whatever.. I really don’t care, but here is the end photo from yesterdays work:

Result of a few hours of contruction. EXI-450

Yes, it took several hours to get to that point. It’s harder than it looks. Especially considering these kits do not come with ANY instructions. Thankfully, Will (owner of MikeysRC.com) has taken his time to document 15 10 minutes videos on how to construct one of these helis. I Just completed video #6.

Following are some snapshots I took during the construction in case you find the need to keep reading.

3500kv brushless motor mounted
Motor adjusment bolts. Locktite applied.
Tail drive belt, adjusted to proper tension.
Using grinder to open servo openings, required for some servos.
One of the cyclic servos installed in frame
2 of 3 cyclic servos installed. Hot glue used to hold nuts for install.
3rd of the 3 cyclic servos installed (rear)
3 cyclic servos installed, starting to check control arm alignment.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.